SoundDock Portable NONE OF THE ABOVE Your serial number could either be from a SoundDock Series II or a SoundDock Portable, please select which image your SoundDock resembles below. Results 1 - 48 of 139 - Get the best deal for Bose Sounddock Series Ii from the largest online. And have switched to a new phone so I am selling the SoundDock.
©2008 Bose Corporation Reference Number 277378-SM Rev. 12 Service Manual SoundDock® Digital Music System with original Firewire charging 2004-2008 Electronic Copy Only This Service Manual applies to original SoundDock systems built before 8/8/08, DOM 8221. For SoundDock sys- tems built after 8/8/08, use the new SoundDock manual with “USB iPod Charging” part number 277378-SM_USB. To determine the SoundDock version, use the date of manufacture (DOM) encoded within the serial number located on the product label Serial Number example - 040105AE Characters 8 to 11 identifiy the DOM - 7342 7342 = the 342nd day of 2007 Both products share the same name and most of the same mechanical assemblies. However, the electronics are not interchangeable. 2 CONTENTS Safety Information........
3 Specifications......... 4 Product Description........ 5 Part List Notes........
6 Electrostatic Discharge Sensitive (ESDS) Device Handling.... 6 Warranty......... 6 USB Update Procedure........
7 New iPod Charging Circuit....... 8 Packaging Part List........ Packaging Part List.......9 MAIN PART LIST, SoundDock ® Speaker Assembly..... Speaker Assembly.......10 MAIN PART LIST, Welded Enclosure Assembly..... Welded Enclosure Assembly......11 MAIN PART LIST, Docking Cradle Assembly..... 
Docking Cradle Assembly......12 Electrical Part Lists....... 13-19 Disassembly Procedures.......20-23 Test Procedures........ 24 Revision History........ 3 SAFETY INFORMATION 1.Parts that have special safety characteristics are identified by the symbol on schematics or by special notes on the parts list. Use only replacement parts that have critical characteristics recommended by the manufacturer. Make leakage current or resistance measurements to determine that exposed parts are acceptably insulated from the supply circuit before returning the unit to the customer. Use the following checks to perform these measurements: A.
Leakage Current Hot Check-With the unit completely reassembled, plug the AC line cord directly into a 120V AC outlet. (Do not use an isolation transformer during this test.) Use a leakage current tester or a metering system that complies with American National Standards Institute (ANSI) C101.1 “Leakage Current for Appliances” and Underwriters Laboratories (UL) UL6500 / UL60065 / IEC 60065 paragraph 9.1.1. With the unit powered on, measure from a known earth ground (metal water pipe, conduit, etc.) to all exposed metal parts of the unit (antennas, handle bracket, metal cabinet, screw heads, metallic overlays, control shafts, etc.), especially any exposed metal parts that offer an electrical return path to the chassis. Any cur- rent measured must not exceed 0.5 milliamp. Reverse the unit power cord plug in the outlet and repeat test. ANY MEASUREMENTS NOT WITHIN THE LIMITS SPECIFIED HEREIN INDICATE A POTENTIAL SHOCK HAZARD THAT MUST BE ELIMINATED BEFORE RETURNING THE UNIT TO THE CUSTOMER.
Insulation Resistance Test Cold Check-(1) Unplug the power supply and connect a jumper wire between the two prongs of the plug. (2) Turn on the power switch of the unit. (3) Measure the resistance with an ohmmeter between the jumpered AC plug and each exposed metallic cabinet part on the unit. When testing 3 wire products, the resistance measured to the product enclosure should be between 2 and infinite MOhms. Also, the resistance measured to exposed input/output connectors should be between 4 and infinite MOhms.